Dodge Charger: MIRRORS / Illuminated Vanity Mirrors

Dodge Charger 2011-2025 Owner's Manual / GETTING TO KNOW YOUR VEHICLE / MIRRORS / Illuminated Vanity Mirrors

To access an illuminated vanity mirror, flip down one of the visors and lift the cover.

Dodge Charger. Illuminated Vanity Mirrors

Sun Visor “Slide-On-Rod” Feature — If Equipped

The sun visor “Slide-On-Rod” feature allows for additional flexibility in positioning the sun visor to block out the sun.

Fold down the sun visor.
Unclip the visor from the corner clip.
Pivot the sun visor toward the side window.
Extend the sun visor for additional sun blockage.

Dodge Charger. Illuminated Vanity Mirrors

NOTE:

The sun visor can also be extended while the sun visor is against the windshield for additional sun blockage through the front of the vehicle.

Automatic Dimming Mirror — If Equipped

The rearview mirror can be adjusted up, down, left, and right. The mirror should be adjusted to center on the view through the rear window. This mirror automatically adjusts for headlight glare from vehicles behind you...

Outside Mirrors, Driver's Outside Automatic Dimming Mirror — If Equipped

The outside mirror(s) can be adjusted to the center of the adjacent lane of traffic to achieve the optimal view. WARNING! Vehicles and other objects seen in an outside convex mirror will look smaller and farther away than they really are...

Other information:

Dodge Charger 2011-2025 Owner's Manual: REFUELING THE VEHICLE

Put the vehicle in PARK and switch the ignition off. Push near the rear edge and center of the of the fuel filler door to release. The door will pop open to allow hand access to open the door the rest of the way. Open the fuel filler door...

Dodge Charger 2011-2025 Owner's Manual: Programming HomeLink® To A Miscellaneous Device, Reprogramming A Single HomeLink® Button

Programming HomeLink® To A Miscellaneous Device Follow the procedure on programming HomeLink® to a garage door opener. Be sure to determine if the device has a rolling code, or non-rolling code before beginning the programming process. NOTE: Canadian radio frequency laws require trans- mitter signals to time-out (or quit) after several seconds of transmission, which may not be long enough for HomeLink® to pick up the signal during programming...