Dodge Charger: OCCUPANT RESTRAINT SYSTEMS / Installing Child Restraints Using The Top Tether Anchorage:
WARNING!
Do not attach a tether strap for a rear-facing car seat to any location
in front of the car seat, including the seat frame or a tether anchorage. Only attach
the tether strap of a rear-facing car seat to the tether anchorage that is approved
for that seating position, located behind the top of the vehicle seat.

- Look behind the seating position where you plan to install the child restraint
to find the tether anchorage. You may need to move the seat forward to provide
better access to the tether anchorage. If there is no top tether anchorage for
that seating position, move the child restraint to another position in the vehicle
if one is available.
- Rotate or lift the cover to access the anchor directly behind the seat where
you are placing the child restraint.
- Route the tether strap to provide the most direct path for the strap between
the anchor and the child seat. If your vehicle is equipped with adjustable rear
head restraints, raise the head restraint, and where possible, route the tether
strap under the head restraint and between the two posts. If not possible, lower
the head restraint and pass the tether strap around the outboard side of the
head restraint.

2 — Cover
3 — Attaching Strap
A — Tether Strap Hook
B — Tether Anchor
- Attach the tether strap hook of the child restraint to the top tether anchorage
as shown in the diagram.
- 5. Remove slack in the tether strap according to the child restraint manufacturer’s
instructions.
WARNING!
- An incorrectly anchored tether strap could lead to increased head
motion and possible injury to the child. Use only the anchorage position directly
behind the child seat to secure a child restraint top tether strap.
- If your vehicle is equipped with a split rear seat, make sure the
tether strap does not slip into the opening between the seat- backs as you remove
slack in the strap.
Center Tether Attachment
- If adjustable, lower the adjustable center head restraint to the full down
position.
- Route the tether strap over the seatback and head restraint.
- Attach the tether strap hook of the child restraint to the center tether
anchorage located in the panel between the rear seatback and the rear window.
- Remove slack in the tether strap according to the child restraint manufacturer’s
instructions.
Child restraint systems are designed to be secured in vehicle seats by lap belts
or the lap belt portion of a lap/shoulder belt.
WARNING!
Improper installation or failure to properly secure a child restraint
can lead to failure of the restraint...
Other information:
© 2020 FCA US LLC. All rights reserved. Mopar and Uconnect are registered trademarks
and Mopar Owner Connect is a trademark of FCA US LLC. Android™ is a trademark of
Google Inc. SiriusXM® and all related marks and logos are trademarks of SiriusXM®
Radio Inc...
The LaneSense button is located
on the center stack below the Uconnect display.
To turn the LaneSense system on, push the LaneSense button (LED turns off). A
“LaneSense On” message is shown in the instrument cluster display.
To turn the LaneSense system off, push the LaneSense button once (LED turns on)...