Dodge Charger: REMOTE START (IF EQUIPPED) / Remote Start Comfort Systems — If Equipped
When Remote Start is activated, the front and rear defrost will automatically
turn on in cold weather. The heated steering wheel and driver heated seat feature
will turn on if selected in the comfort menu screen within Uconnect Settings Ú page
138. In warm weather, the driver vented seat feature will automatically turn on
when the Remote Start is activated, if programmed in the comfort menu screen. The
vehicle will adjust the climate control settings depending on the outside ambient
temperature.
Automatic Temperature Control (ATC) — If Equipped
The climate controls will be automatically adjusted to the optimal temperature
and mode settings depending on the outside ambient temperature. This will occur
until the ignition is placed in the ON/RUN position where the climate controls will
resume their previous settings.
Manual Temperature Control (MTC) — If Equipped
- In ambient temperatures at 40°F (4.5°C) or below, the climate settings will
default to maximum heat, with fresh air entering the cabin. If the front defrost
timer expires, the vehicle will enter Mix mode.
- In ambient temperatures from 40°F (4.5°C) to 78°F (26°C), the climate settings
will be based on the last settings selected by the driver.
- In ambient temperatures at 78°F (26°C) or above, the climate settings will
default to MAX A/C, Bi-Level mode, with Recirculation on.
For more information on ATC, MTC, and climate control settings.
NOTE:
These features will stay on through the duration of Remote Start until the ignition
is placed in the ON/RUN position. The climate control settings will change if manually
adjusted by the driver while the vehicle is in Remote Start mode, and exit automatic
override. This includes the OFF button on the climate controls, which will turn
the system off.
Remote Start Windshield Wiper De–Icer Activation — If Equipped
When Remote Start is active and the outside ambient temperature is less than
33°F (0.6°C), the Windshield Wiper De-Icer will activate. Exiting Remote Start will
resume its previous operation. If the Windshield Wiper De-Icer was active, the timer
and operation will continue.
To drive the vehicle after starting the Remote Start system, either push and
release the unlock button on the key fob to unlock the doors, or unlock the vehicle
using Keyless Enter-N-Go — Passive Entry via the door handles, and disarm the Vehicle
Security system (if equipped)...
The following messages will display in the instrument cluster display if the
vehicle fails to Remote Start or exits Remote Start prematurely:
Remote Start Cancelled — Door Open
Remote Start Cancelled — Hood Open
Remote Start Cancelled — Fuel Low
Remote Start Cancelled — Trunk Open
Remote Start Disabled — Start Vehicle To Reset
The instrument cluster display message stays active until the ignition is placed
in the ON/RUN position...
Other information:
KEYLESS ENTER-N-GO IGNITION
This feature allows the driver to operate the ignition switch with the push of
a button as long as the key fob is in the passenger compartment.
The START/STOP ignition button has four operating positions, three of which are
labeled and will illuminate when in position...
Children who are large enough to wear the shoulder belt comfortably, and whose
legs are long enough to bend over the front of the seat when their back is against
the seatback, should use the seat belt in a rear seat. Use this simple 5-step test
to decide whether the child can use the vehicle’s seat belt alone:
Can the child sit all the way back against the back of the vehicle seat?
Do the child’s knees bend comfortably over the front of the vehicle seat
– while the child is still sitting all the way back?
Does the shoulder belt cross the child’s shoulder between the neck and arm?
Is the lap part of the belt as low as possible, touching the child’s thighs
and not the stomach?
Can the child stay seated like this for the whole trip?
If the answer to any of these questions was “no,” then the child still needs
to use a booster seat in this vehicle...
Categories
To access an illuminated vanity mirror, flip down one of the visors and lift
the cover.

Sun Visor “Slide-On-Rod” Feature — If Equipped
The sun visor “Slide-On-Rod” feature allows for additional flexibility in positioning
the sun visor to block out the sun.
Fold down the sun visor.
Unclip the visor from the corner clip.
Pivot the sun visor toward the side window.
Extend the sun visor for additional sun blockage.
read more