Dodge Charger: Automatic Climate Control Descriptions And Functions / SYNC Button, Blower Control
SYNC Button
Press the SYNC button on the touchscreen
to toggle the SYNC feature on/off. The SYNC indicator illuminates when SYNC is on.
SYNC synchronizes the passenger temperature setting with the driver temperature
setting. Changing the passenger’s temperature setting while in SYNC will automatically
exit this feature.
NOTE:
The SYNC button is only available on the touch- screen.
Blower Control
Blower Control regulates the amount
of air forced through the Climate Control system. There are seven blower speeds
available. Adjusting the blower will cause automatic mode to switch to manual operation.
The speeds can be selected using either the blower control knob on the faceplate
or the buttons on the touchscreen.
Faceplate
The blower speed increases as you turn the blower control knob clockwise from the lowest blower setting. The blower speed decreases as you turn the blower control knob counterclockwise.
Touchscreen
Use the small blower icon to reduce the blower setting and the large blower icon to increase the blower setting. Blower can also be selected by pressing the blower bar area between the icons.
Driver And Passenger Temperature Up And Down Buttons
These buttons provide the driver and passenger with independent temperature control.
Push the red button on the faceplate
or touchscreen or press and slide the temperature bar towards the red arrow button
on the touchscreen for warmer temperature settings...
Mode Control, Panel Mode
Mode Control
Select Mode by pressing one of
the Mode buttons on the touchscreen to change the airflow distribution mode. The
airflow distribution mode can be adjusted so air comes from the instrument panel
outlets, floor outlets, defrost outlets, and demist outlets...
Other information:
Dodge Charger 2011-2026 Owner's Manual: LaneSense Operation
The LaneSense system is operational at speeds above 37 mph (60 km/h) and below 112 mph (180 km/h). The LaneSense system uses a forward looking camera to detect lane markings and measure vehicle position within the lane boundaries. When both lane markings are detected and the driver unintentionally drifts out of the lane (no turn signal applied), the LaneSense system provides a haptic warning in the form of torque applied to the steering wheel to prompt the driver to remain within the lane boundaries...
Dodge Charger 2011-2026 Owner's Manual: Front Head Restraint Removal
To remove the head restraint, raise it up as far as it can go. Then, push the adjustment button and the release button at the base of each post while pulling the head restraint up. To reinstall the head restraint, put the head restraint posts into the holes...
Categories
- Manuals Home
- Dodge Charger Owners Manual
- Dodge Charger Service Manual
- WHEEL AND TIRE TORQUE SPECIFICATIONS
- Launch Control
- High/Low Beam Switch, Automatic High Beam — If Equipped
- New on site
- Most important about car
Manual Door Locks
The power door locks can be manually locked from inside the vehicle by using the door lock knob. To lock each door, push the door lock knob on each door trim panel downward. To unlock the front doors, pull the inside door handle to the first detent. To unlock the rear doors, pull the door lock knob on the door trim panel upward. If the lock knob is down when the door is closed, the door will lock.
