Dodge Charger: LANESENSE — IF EQUIPPED / LaneSense Warning Message
The LaneSense system will indicate the current lane drift condition through the
instrument cluster display.
Premium Instrument Cluster Display
When the LaneSense system is on, the lane lines are gray when both of the lane
boundaries have not been detected and the LaneSense telltale is solid white.
https://ecufix.info 
Left Lane Departure — Only Left Lane Detected
- When the LaneSense system is on, the Lane- Sense telltale is solid white
when only the left lane marking has been detected and the system is ready to
provide visual warnings in the instrument cluster display if a lane depar- ture
occurs.
- When the LaneSense system senses the lane has been approached and
is in a lane depar- ture situation, the left lane line flashes yellow (on/off),
and the LaneSense telltale changes from solid white to flashing yellow.
NOTE:
The LaneSense system operates with similar behavior for a right lane departure
when only the right lane marking has been detected.
Left Lane Departure — Both Lanes Detected
- When the LaneSense system is on, the lane lines turn from gray to white
to indicate that both of the lane markings have been detected. The LaneSense
telltale is solid green when both lane markings have been detected and the system
is “armed” to provide visual warnings in the instrument cluster display and
a torque warning in the steering wheel if an unintentional lane depar- ture
occurs.
- When the LaneSense system senses a lane drift situation, the left lane line
turns solid yellow. The LaneSense telltale changes from solid green to solid
yellow. At this time torque is applied to the steering wheel in the oppo- site
direction of the lane boundary.
For example, if approaching the left side
of the lane the steering wheel will turn to the right.
- When the LaneSense system senses the lane has been approached and is in
a lane depar- ture situation, the left lane line flashes yellow (on/off). The
LaneSense telltale changes from solid yellow to flashing yellow. At this time
torque is applied to the steering wheel in the opposite direction of the lane
boundary.
For example, if approaching the left side of the lane the steering
wheel will turn to the right.

NOTE:
he LaneSense system operates with similar behavior for a right lane departure.
The LaneSense button is located
on the center stack below the Uconnect display.
To turn the LaneSense system on, push the LaneSense button (LED turns off)...
The LaneSense system has settings to adjust the intensity of the torque warning
and the warning zone sensitivity (early/med/late) that you can configure through
the Uconnect system...
Other information:
The Vehicle Security system can be disarmed using any of the following methods:
Push the unlock button on the key fob.
Grab the Passive Entry door handle to unlock the door.
Cycle the ignition out of the OFF position to disarm the system.
NOTE:
The driver's door key cylinder and the trunk button on the key fob cannot
arm or disarm the Vehicle Security system...
The BSM system uses two radar sensors, located inside the rear fascia/bumper,
to detect highway licensable vehicles (automobiles, trucks, motorcycles, etc.) that
enter the blind spot zones from the rear/front/side of the vehicle.
When the vehicle is started, the BSM Warning Light will momentarily illuminate
in both outside rearview mirrors to let the driver know that the system is operational...